DIYAUTOFIXESMANUALS

Diagnostic Trouble Code Database

C1136Moderate (Fix Soon)

Gear Select position short to ground

System:Chassis Systems (Brakes & Suspension)•Classification:Chassis (OBD-II Generic)•Severity Impact:Chassis dynamics or electronic stability assist unavailable.
Direct Technical Definition (Fast Answer)

Code C1136 indicates a diagnostic fault in the Chassis Systems (Brakes & Suspension) (Gear Select position short to ground). Connect an OBD2 scanner to verify freeze frame data, then test circuit voltage and vacuum connections before replacing components.

Estimated Repair Time30 – 60 minutes
DIY Parts Cost$30 – $75
Shop Repair Quote$200 – $420
Average DIY SavingsSave $200+
The 80/20 Workshop Rule

Inspect the electrical harness and ground connection related to C1136. Clear the code with an OBD2 scanner; if it returns, perform a multimeter resistance check on the primary sensor.

Estimated DIY Cost
$30 – $75
Tools & DIY parts
Dealership Shop Quote
$200 – $420
Labor ($180/hr) + parts
Net Money Saved
Save $200+
In your driveway today

Symptoms Associated with C1136

Drivers typically observe the following symptoms when the ECM flags C1136:

Check Engine Light (MIL) illuminated on instrument cluster
Possible engine performance, hesitation, or emission monitor reset
Failed annual vehicle safety or emissions smog inspection

Common Root Causes & Statistical Probability Matrix

Statistical breakdown of what triggers this code based on automotive repair shop data.

Worn, contaminated, or defective Gear Select position short to ground component
High ProbabilityDifficulty: Moderate
Relative Frequency: 75%Estimated Parts Cost: Low
Damaged, loose, or corroded wiring harness connector pins
Medium ProbabilityDifficulty: Easy
Relative Frequency: 45%Estimated Parts Cost: Low
Underlying vacuum leak, blown fuse, or poor chassis ground
Low ProbabilityDifficulty: Easy
Relative Frequency: 20%Estimated Parts Cost: Low

Step-by-Step Diagnostic & Repair Procedure

Follow this logical order to isolate and repair C1136 before spending money on costly parts.

Checklist Progress: 0 of 3 steps complete

Step 1: Scan and Record Freeze Frame Data

Connect an OBD2 scanner, record engine RPM, coolant temp, and secondary DTCs associated with C1136.

Step 2: Visual Inspection

Inspect wiring harnesses, pins, and vacuum lines related to the Chassis Systems (Brakes & Suspension) for chafing, oil contamination, or burn marks.

Step 3: Multimeter / Component Verification

Measure 12V reference power, ground continuity, and signal voltage against factory service manual specifications for C1136.

Frequently Asked Questions About C1136

Severity is rated as Moderate. Chassis dynamics or electronic stability assist unavailable.